Port Coquitlam Scissor Lift Certification

Port Coquitlam Scissor Lift Certification - Numerous worksites and tradespeople like for instance welders, masons and iron workers utilize scissor lift platforms in order to help them reach elevated work places. The operation of a scissor lift is usually secondary to their trade. Hence, it is essential that all operators of these platforms be well trained and certified. Industry, lift manufacturers and regulators work together to be able to make certain that operators are trained in safely using work platforms.

Work platforms are likewise referred to as manlifts or AWPs. These machinery are stable and easy to use, although there is always some danger as they lift individuals to heights. The following are some important safety concerns common to AWPs:

To protect individuals working around work platforms from accidental discharge of power because of close working proximities to power lines and wires, there is a minimum safe approach distance (also referred to as MSAD). Voltage could arc across the air and cause injury to workers on a work platform if MSAD is not observed.

In order to guarantee maximum steadiness, care should be taken when lowering the work platform. If you move the load towards the turntable, the boom should be retracted. This would help maintain steadiness during lowering of the platform.

The regulations regarding tie offs do not mandate individuals working on a scissor lift to tie themselves off. Several groups would however, require their employees to tie off in their employer guidelines, local regulations or job-specific risk assessment. The manufacturer-provided anchorage is the only safe anchorage wherein lanyard and harness combinations should be attached.

Observe the maximum slope rating and do not exceed it. A grade could be measured by laying a straight edge or board on the slope. Next, a carpenter's level can be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope can be determined.

A standard walk-around check has to be carried out to determine if the unit is mechanically safe. A site assessment determines if the work area is safe. This is vital especially on changing construction sites because of the chance of obstacles, unimproved surfaces, and contact with power lines. A function test should be performed. If the unit is operated safely and properly and correct shutdown procedures are followed, the risks of incident are really reduced.

Click to Download the pdf